Here is my A4000TX (find out more about the project over at Amibay) as it looks today. The A4000TX is an A4000CR clone in a standardized ATX/EATX form factor. I am running this setup as my primary Amiga. I decided to do two fixes to the system today, quiet the fans and place the ZuluSCSI on the Re4091 SCSI 3 board.

A4000TX cooling with Noctua fans

I am running an old 120mm Noctua fan as the intake and a small 40mm Noctua fan on the turbo card. I wanted to make them more quiet. I solved it by adding an old Zalman Fanmate to the turbo card fan and running the fan on the slowest setting. I added a Noctua fan silencer on the intake fan. The case is nowhere silent but a lot better than running the fans stock.

While you could argue a 120mm intake fan is a bit overkill I think that it wont hurt in the long run as a colder computer lasts longer.

There is a third fan in the PSU but it rarely spins up as the system consumes so little power compared to a modern PC.

A4000TX Zorro cards and cable chaos

Here is a closeup of the cards I am running. The upper card is the ZZ9000AX sound card, then we have the ZZ9000 graphics card, then barely noticeable is the GottaGoFaZt3r memory card, under that a Zorro-LAN-IDE card providing the clock port for the Solas on the Solas ISA carrier in front of it and finally the ReA4091 on the bottom slot.

I managed to fit both the ISA Solas carrier and the ZuluSCSI that is fitted to the 4091, there is not even a mm space left between them. Before I had the ZuluSCSI mounted on the case back, but it looks much better fitted directly to the 4091 card. Since getting the 4091 working with my 100MHz BFG 9060 I decided to keep it in this system.

As you can see there are quite a lot of cables all over the place. No doubt this can be improved.